BMK REMOTE DT Band-Burner

I will restock from BMK as necessary.  BMK text.

BB-RDT is a lightweight (1.1g) RDT/timer solution with a Band Burner. 

Battery input is JST 1.25mm for a solderless installation, but you can also remove them for a smaller footprint if you have a fine soldering iron and you will find bigger pads under the connectors.  

The onboard receiver is compatible with all BMK  transmitters(B1, B2, FlexiDisplay and Skylink) which can be ordered as a bundle or sold separately. Each transmitter has its unique code and you can connect a transmitter with an unlimited number of receivers. 

Download the official BMK RDT Band Burner Instruction sheet HERE.

Here are the simple instructions for programming:
USAGE:
with the battery plugged in, the unit is on standby, indicated by a slow flashing red LED

LONG PRESS the button to start the countdown - indicated by a fast flashing red LED
to STOP the countdown, press the button - this is back to standby
LONG PRESS again to start the countdown again
if your red LED is blinking is a fast series of three while on standby, yoru battery needs charged

PROGRAMMING THE TIMER:
a new timer will have a minimal time pre-set.  To use, you will need to set your own time

to start the programming sequence, UNPLUG the battery
PLUG IN the battery WHILE HOLDING DOWN THE BUTTON - indicated by the red LED ON
release the button
now HOLD the BUTTON and observe the blinking LED - each blink is 10 SECONDS
RELEASE the BUTTON when you reach your desired time (120 seconds = 12 blinks)
the burner is on standby, indicated by a slow flashing red LED
use the timer or unplug the battery
the programmed time is saved, even when the battery is unplugged.